Dr. Pleil with Student at the MTTC
Teaching students about Microsystems Fabrication
Barbara Lopez at the MTTC
Teaching students the importance of safety in the clean room
Mathew, Olivia and Andy
Developing the chamber (backside) pressure sensor pattern
Olivia in the MTTC
Olivia is an EET student from Ivy Tech learning about MEMS fabrication
March Reactive Ion Etcher
Etching the Silicon Nitride hard mask
Rick and Andy using the March RIE
Rick and Andy etching the backside chamber mask pattern into the silicon nitride hard mask.
Rick using the "AAA" rule
Rick from Rio Salado learning how to fabricate a MEMS Pressure Sensor at UNM's MTTC cleanroom
SCME PS Workshop
Team Work during the SCME 8/2015 PS Workshop
Metal Evaporation
SCME Workshop - Cr/Au evaporation

Check out our latest publication "Teach MEMS On a Tight Budget" - March Issue of Tech Directions! This was a colalboratively written article between Matthias Pleil and G.H. Massiha.  "GH" attended one of SCME's pressure sensor cleanroom workshops at our Univeristy of South Florida partner site.  GH uses and advocates the use of SCME materials in STEM classes.

Footer

Copyright © 2017 SCME. All Rights Reserved.
Joomla! is Free Software released under the GNU General Public License.